|
Who's Online
There currently are 5984 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
The product manual I received was exactly what I was looking for, delivered painlessly at a very fair price. I can't ask for any more than that.
;
Very well done!!!!! congratulations. It was a bit longer than usual the wiating time even if it was on time (in 24 hours).
;
Last week I bought a second hand BAUKNECHT TRK4850 DRYER. It is a professional machine with many programs and switch options. I feared it would be a huge quest to find a manual. I was delighted when I found owner-manuals.com. After payment I received the file to download the next day already. The quality is great. I am very happy. Thanks!
but kindly the distributions of the operating programs not find in the owners manual,can you help me to understand the operating programs instructions thank you
;
Very good copy, very readable and easy transaction as always.
;
It is perfect, exactly what we needed. It's like the paper version but less clutter.
AM (MW/LW) antenna connection
Connect the AM (MW/LW) loop antenna supplied to the AM LOOP terminals. Turn the loop until you have the best reception. � If the reception is poor, connect an outdoor single vinyl-covered wire to the AM EXT terminal. Keep the AM (MW/LW) loop antenna connected.
Connecting the Speakers
After connecting the front, center and rear speakers, and/or a subwoofer, set the speaker setting information properly to obtain the best possible Surround effect. For details, see page 15. CAUTION:
Use speakers with the SPEAKER IMPEDANCE indicated by the speaker terminals.
FM antenna connection
Connect the FM antenna supplied to the FM 75 � COAXIAL terminal as temporary measure. Extend the supplied FM antenna horizontally. � If the reception is poor, connect an outdoor FM antenna (not supplied). Before attaching a 75 � coaxial cable (with a standard type connector), disconnect the supplied FM antenna.
Connecting the front, center, and rear speakers
1
2
2 1
3
Notes: � If the AM (MW/LW) loop antenna wire is covered with vinyl, remove the vinyl while twisting it as shown on the right. � Make sure the antenna conductors do not touch any other terminals, connecting cords and power cord. This could cause poor reception.
For each speaker, connect the (+) and (�) terminals on the rear panel to the (+) and (�) terminals marked on the speakers respectively.
1 Cut, twist and remove the insulation at the end of each speaker cord (not supplied). 2 Press and hold the clamp of the speaker terminal (1), then insert the speaker cord (2). 3 Release the finger from the clamp.
Connecting the subwoofer speaker
By connecting a subwoofer, you can enhance the bass or reproduce the original LFE signals recorded in the digital software.
RIGHT RIGHT
LEFT/MONO
Getting Started
INPUT (LOW-LEVEL)
Powered subwoofer (example)
SUBWOOFER OUT
Connect the input jack of a powered subwoofer to the SUBWOOFER OUT jack on the rear panel, using a cable with RCA pin plugs (not supplied). � Refer also to the manual supplied with your subwoofer.
Note: You can place a subwoofer wherever you like since bass sound is non-directional. Normally place it in front of you.
5
|
|
|
> |
|