There are currently no product reviews.
Very satisfied! I was searching for several days, but nope; till I discovered your webside and there it was at a very reasonable price. Keep up the good work!
Generally speaking good copy; a few pages too hard contrast...
Good service and communication.
I purchased the unit from a private party and the original owners manual was not available. Having the ability to download it was extremely helpful and clarified operating the equipment immensely. This is a complicated unit and without the manual I would not have been able to maximize it's potential. Thank you.
Being a user of older radios of many kinds, preferring them over more modern rigs, this manual was invaluable in the programming of my two. I now know for certain what the assorted buttons functions are, and am very grateful to have found this excellent site. Many thanks for your assistance, Tony.
Clear and easy to read. All details as expected. Price acceptable , and quick delivery.
Before connecting this unit to the amplifier (or receiver), observe the following carefully. â¢ Turn off the amplifier. â¢ Make all connections before plugging in this unit.
â¢ DO NOT connect this unit to the REC OUT jacks of your amplifier. It may damage your subwoofer.
Monaural audio cord (Supplied) Amplifier or Receiver
To LINE OUT
To SUBWOOFER OUT or MONO To an AC outlet SP-PWE5 Stereo audio cord (not Supplied) In the case that the receiver dose not have the SUBWOOFER OUT or MONO terminal. SP-DWF10 To an AC outlet
SP-PWE5 (Front) SP-PWE5 (Rear) SP-DWF10 (Front) SP-DWF10 (Rear)
Turning On the PowerâPOWER
To turn on the power. Press the POWER switch to the [ â or â¢ The power lamp lights in green.
Operating the Unit Automatically According to the Incoming SignalsâAUTO POWER ON/STANDBY
To activate AUTO POWER ON/STANDBY. Press the AUTO POWER ON/STANDBY switch to the [ position. â¢ If no sound comes in for 5-10 minutes, the unit enters standby mode. The power lamp lights in red. â¢ If the unit detects incoming signals, the unit starts operating. The power lamp lights in green. To cancel AUTO POWER ON/STANDBY. Press out the AUTO POWER ON/STANDBY switch to set it to the [ ] CANCEL position.
AUTO POWER ON / STANDBY
] ON position.
To cut of the power. Press the POWER switch to the [ â¡ or â¢ The power lamp goes out. â¢ This will disconnect the mains lead.
] OFF position.
When the volume level of the amplifier is so low or the incoming signals are so weak that this unit cannot detect sounds, Auto Power On/Standby may not work correctly.