|
Who's Online
There currently are 6043 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
What can i say but i would have been lost without your support.
Thank You!
;
Très satisfait ! envoi rapide, Grand catalogue disponible. Many thanks !
;
Delivery came quite promptly and in a very readable format. Thank you.
;
I found my Clarion VRX8370R in the Camper I bought and I wasn't able for month to understand it.
The Owner Manual was perfect and just what I was searching for.
Thank you.
Leonardo
;
Very good copy of Manual, clear and easy to print off, arrived very promptly and reasonably priced.
Thanks, I will use you again.
42 EN
PRO HD SYSTEM
This PRO HD system can perform playback of the D-VHS tape recorded by the MPEG2-TS signal. This VCR can check the tape condition during playback (and recording), and realizes the best possible pictures.
PRO HD System Playback
� Turn on the VCR and the TV, and select the AV mode on the TV. � Set the VCR/TV/CABLE/DBS selector on the Remote to �VCR�.
Please refer to next page, when you playback the tape on which the password was set up.
1 Load a D-VHS cassette
Make sure the window side is up, the rear label side is facing you and the arrow on the front of the cassette is pointing towards the VCR. Do not apply too much pressure when inserting. � The VCR turns on automatically. � The tape will run for a few seconds while the VCR searches for the tape number. If the tape number is found, it will be shown on the TV screen if �SUPERIMPOSE� is set to �ON� ( pg. 59). � The counter is reset automatically, however, it is not completely reset to �0:00:00�. � If the cassette�s record safety tab has been removed, playback begins automatically.
POWER
1
STOP/EJECT (7/0)
2
IN F-1
+
REW ( ) FF (
)
POWER
VCR CABLE TV /DBS
2 Start playback
To stop playback
Press PLAY ( 3 ). � Tape speed is automatically detected.
Press STOP ( 7 ) on the Remote or STOP/EJECT ( 7/0 ) on the front panel.
To rewind the tape (when it is not running)
Press REW ( 1 ).
To fast-forward (when it is not running)
Press FF ( ¡ ).
2
REW(1) FF(¡) STOP(7)
To eject the tape
Press STOP/EJECT ( 7/0 ) on the front panel when the tape is not running. � You can also eject the cassette when the VCR is turned off.
To turn off the VCR
Press POWER.
|
|
|
> |
|