|
Who's Online
There currently are 5875 guests and 5 members online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
High-quality scanning. Detailed description. Recommend for all technician. A+++
;
This is a good quality scan of the original Service Manual from Nordmende, Germany. Contains the circuit diagram, PCB layout, adjust/tune instructions as well. It is NOT in English but in GERMAN language! That was quite right for my german friend from the lower east side in Berlin.
;
Received via e-mail this PDF manual is worth the money. This is a quality scan of a manual in excellent condition and is just as good as having the original manual in hand. I have later seen the original manual and it was printed in colour, but this particular manual is black & white but scan resolution is high end quality! All drawings and pictures are presented in great detail. So, nearly perfect score in my opinion.
If you own the turntable you also should own the manual!
;
I was very satisfied with the service manual I ordered and downloaded. I will definitely buy again from this seller.
;
Great product. Recieved it fast...exactly as advertised.
UX-F70MD/UX-F72MD
Removing the Mechanism P.C. Board (Refer to Fig 10.)
Flexible wire
Reference:The mechanism P.C. board can be removed without removal of the TRAMECHA assembly.
C
Shorting round
Note: Before disconnecting the flexible wire coming from the pickup from the connector, be sure to solder its shorting round. If the flexible wire is connected without soldering, it may cause breakdown of the pickup. 1. Solder the shorting round of the flexible wire connected with the mechanism P.C. board from the back of the mechanism assembly. 2. Disconnect the flexible wire from the connector CN601 on the mechanism P.C. board. 3. Remove the three screws C fastening the mechanism P.C. board. 4. Unsolder the two points of the part h and one point of the part i of the mechanism P.C. board. Then, remove the mechanism P.C. board upwards. Note: When reinstalling the mechanism P.C. board, connect the flexible wire coming from the pickup to the connector first and then remove the solder from the shorting round of the flexible cable.
Soldered part h
CN601 on mechanism P.C. board
C
C
Soldered part i
Fig. 10
1-32
|
|
|
> |
|