5 star quality on these downloadable manuals. Easy to read and all the information is there. A must when doing a custom install or needing to service your precious old school electronics.
Please tell us what you think and share your opinions with others. Be sure to focus your comments on the product. You will receive $2.00 of store credit for Your review.
Please tell us what you think and share your opinions with others. Be sure to focus your comments on the product. You will receive $2.00 of store credit for Your review.
Text excerpt from page 13 (click to view)
Listening to FM and AM Broadcasts
Setting the Tuner Interval Spacing
You can select 10 kHz or 9 kHz apart for the AM tuner interval spacing and 100 kHz or 50 kHz apart for the FM tuner interval spacing. � You need to do this setting separately for each band.
Tuning in to a Station
1 Press TUNER/BAND to select either
�FM� or �AM.�
TUNER /BAND
On the unit ONLY:
1 Press TUNER/BAND to select either
�FM� or �AM.�
TUNER /BAND
The unit automatically turns on and tunes in to the previously received station�either FM or AM. � Each time you press the button, the band alternates between FM and AM.
The unit automatically turns on and tunes in to the previously received station�either FM or AM. � Each time you press the button, the band alternates between FM and AM.
2 Press and hold ¢ or 4
(or ¡/¢ or 4/1 on the unit) for more than 1 second.
� ¢ (¡/¢): � 4 (4/1): Increases the frequencies. Decreases the frequencies.
2 Press
STANDBY/ON while holding down 7.
� Each time you press STANDBY/ON, the interval spacing alternates as follows: While selecting the AM tuner 10K (10 kHz) � 9K (9 kHz)
CD CONTROL
STANDBY/ON
The unit starts searching for stations and stops when a station of sufficient signal strength is tuned in. � If an FM program is broadcast in stereo, the ST (stereo) indicator lights up on the display (only when the reception is good). To stop during searching, press ¢ or 4 (or ¡/¢ or 4/1 on the unit).
While selecting the FM tuner 100K (100 kHz) � 50K (50 kHz)
When you repeatedly press ¢ or 4 (or ¡/¢ or 4/1 on the unit) The frequency changes step by step.
To change the FM reception mode
When you change the setting The preset stations are erased. You will need to preset the stations again. (See page 11.)
On the remote control ONLY:
When an FM stereo broadcast is hard to receive or noisy, press REPEAT ST/MONO so that the MONO indicator lights up on the display. Reception will improve. To restore the stereo effect, press REPEAT ST/MONO again so that the MONO indicator goes off. In stereo mode, you can hear stereo sound when a stereo program is broadcast.
REPEAT ST/MONO
To reduce the beat�Beat Cut
On the remote control ONLY:
If the beats are heard while listening a broadcast, press BEAT CUT.
BEAT CUT
