There are currently no product reviews.
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Perfect. Very good service and very good scanning quality. All sheets are very legible. Thank's
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
This manual is very helpfull to use the Power Supply. All technical information has been available.
For service use the circuit diagrams are very good.
Very comprehensive document which is a must-have for any Satellit 2100 owner whose set up is somewhat intricate. Due to the bad quality of the pictures that are rather dark and a bit blurred I gave 4-star feedback.
Adjusting the Volume
You can adjust the volume level only while the unit is turned on. The volume level can be adjusted between âVOL MINâ and âVOLUME 1â â âVOLUME 40 (VOL MAX).â When using the remote control, press VOLUME + to increase the volume or press VOLUME â to decrease it. When using the unit, turn VOLUME + / â clockwise (+) to increase the volume or counterclockwise (â) to decrease it.
Reinforcing the Bass Sound
You can reinforce the bass sound to maintain rich, full bass at low volume. â¢ This function only affects the playback sound, but does not affect your recording. To get the effect, press AHB (Active Hyper Bass) PRO until âAHB 1â or âAHB 2â appears on the display. The BASS indicator also lights up on the display. â¢ Each time you press the button, the bass sound change as follows:
AHB 1 AHB 2 AHB OFF (Canceled)
For private listening Connect the headphones to the PHONES jack. No sound comes out of the speakers. Be sure to turn down the volume before connecting or putting on headphones. DO NOT turn off (on standby) the unit with the volume set to an extremely high level; otherwise, a sudden blast of sound can damage your hearing, speakers and/or headphones when you turn on the unit or start playing any source next time. REMEMBER you cannot adjust the volume level while the unit is on standby.
âAHB 2â has much more bass reinforcement effect than âAHB 1.â To cancel the effect, press AHB PRO until âAHB OFFâ appears on the display and the BASS indicator goes off.
Selecting the Illumination Brightness
You can change the illumination brightness only while the unit is turned on.
Adjusting the Tone (Bass/Treble)
You can adjust the bass level (low frequency range) and the treble level (high frequency range) within the range of â5 to +5. Normally set these to 0 (initial setting at factory). â¢ This function only affects the playback sound, but does not affect your recording. â¢ There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.
On the remote control ONLY:
To change the brightness, press DIMMER. â¢ Each time you press the button, the illumination dims and brightens alternately.
1 Press BASS to adjust the bass level or press
TREBLE to adjust the treble level.
2 Press UP to increase the level or press DOWN
to decrease it.
â 10 â
Set of circuit diagrams. The diagrams will be provided as PDF file. The file will be delivered after…
Parts Catalog only. It's available in PDF format. Useful, if Your equipment is broken and You need t…
Complete service manual in digital format (PDF File). Service manuals usually contains circuit diagr…