|
Who's Online
There currently are 5823 guests and 3 members online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
High quality scan of the manual, very quick and easy download and very important, a truly honest price. thanks
;
Minden rendben, de két megjegyzés, az ábrák nehezen kivehetők és a fizetés után 24 órát kell várni a letöltésre.
;
Manual correct, and complete. Downloads cleanly. Format of manual was presumably difficult to PDF to A4, but works reasonably well.
;
This was a hard to find manual. When I did find it , some sites wanted way too much for the file.
Owner-manual .com had it for a really reasonable price. Not only that but it was sent very quickly and was a quality scanned document, unlike some others I purchased from a different site.
Good job guys!!
Larry
;
Fast and courteous service. Product delivered as described. Thank you.
English
Adjusting the Tone (Bass/Treble)
You can adjust the bass level (low frequency range) and the treble level (high frequency range) within the range of �5 to +5. Normally set these to 0 (initial setting at factory). � This function only affects the playback sound, but does not affect your recording. � There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.
Reinforcing the Surround Effect (ONLY FOR UX-L40)
You can reinforce the surround effect. � This function does not affect �your recording. �playback sound of the monaural sources. To get the effect, press SURROUND so that the SURROUND indicator lights up on the display.
SURROUND
SURROUND
1 Press BASS to adjust the bass level or press
TREBLE to adjust the treble level.
BASS TREBLE
BASS TREBLE
SURROUND
To cancel the effect, press SURROUND again so that the SURROUND indicator goes off.
2 Press UP to increase the level or press DOWN
to decrease it.
DOWN UP
Selecting the Illumination Brightness
You can change the illumination brightness only while the unit is turned on.
UP DOWN
On the remote control ONLY:
To change the brightness, press DIMMER. � Each time you press the button, the illumination dims and brightens alternately.
DIMMER
Reinforcing the Bass Sound
You can reinforce the bass sound to maintain rich, full bass at low volume. � This function only affects the playback sound, but does not affect your recording. To get the effect, press AHB (Active Hyper Bass) PRO until �AHB 1� or �AHB 2� appears on the display. The BASS indicator also lights up on the display. � Each time you press the button, the bass sound change as follows:
AHB 1 AHB 2 AHB OFF (Canceled)
BASS
AHB PRO
AHB PRO
�AHB 2� has much more bass reinforcement effect than �AHB 1.� To cancel the effect, press AHB PRO until �AHB OFF� appears on the display and the BASS indicator goes off.
� 11 �
$4.99 UX-L40 JVC Circuit Diagrams Set of circuit diagrams. The diagrams will be provided as PDF file. The file will be delivered after… $4.99 UX-L40 JVC Parts Catalog Parts Catalog only. It's available in PDF format. Useful, if Your equipment is broken and You need t… $4.99 UXL40 JVC Service Manual Complete service manual in digital format (PDF File). Service manuals usually contains circuit diagr…
|
|
|
> |
|