There are currently no product reviews.
as a first-time user and buyer from this site, i found the overall service outstanding!! this product is a godsend as, without it, i would never have been able to find my way around and use my machine as intended. i will certainly use this site again as required. many many thanx!!
This manual is exactly what I needed. This site always has every manual I need, and it is also much less expensive then most other sites. This is the only manual site I will use.
Useful manual, good scan, worth the pay if you find the unit difficult to operate.
Exactly as described, the full user-manual (145 pages). Perfect.
Listening to FM and AM Broadcasts
Tuning In a Station
1 When the unit is turned on, press TUNER/BAND to select tuner mode.
The unit tunes in the last station tuned in (either FM or AM).
You can preset 20 FM and 20 AM stations. â¢ There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.
2 Press TUNER/BAND to select the band, FM or AM.
Each time you press the button, the band selection alternates between FM and AM.
1 Tune in the station you want to preset.
â¢ See âTuning In a Stationâ on the left.
2 Press PROGRAM.
3 Press and hold 4 or Â¢ for more than 1 second.
The PROGRAM indicator and â00â start blinking on the display.
The unit starts searching for stations and stops when a station of sufficient signal strength is tuned in. If a program is broadcast in stereo, the STEREO indicator lights up.
3 Press PRESET â or 5 (or PRE DOWN 8/2 or PRE UP 3/8 on the remote control) to specify the desired preset number.
PRESET DIRECTION PLAY/PAUSE
To stop searching, press 4 or Â¢.
4 To preset more stations, repeat steps 1 to 3 above, allocating a different preset number to each station.
When you press 4 or Â¢ briefly and repeatedly
The frequency changes step by step.
To improve the FM reception
When an FM stereo broadcast is hard to receive or noisy, press REPEAT ST/ MONO to switch to the monaural reception. The STEREO indicator disappears from the display.
When a new station is stored The station previously memorized with the same preset
number is erased. (The frequency of the new station replaces the previous frequency in memory.)
Tuning In a Preset Station
1 Press TUNER/BAND to select tuner mode.
To restore the stereo reception, press REPEAT ST/MONO again so that the STEREO indicator lights up.
To change FM/AM tuning interval
The unitâs default tuning interval is 100 kHz/step for FM reception and 10 kHz/step for AM. You can change this setting to 50 kHz/step for FM and/or 9 kHz/step for AM when using the unit in an area of different frequency allocation system. 1 Press TUNER/BAND to select âFMâ or âAMâ. 2 While holding down STOP/CLEAR 7 on the unit, press VOLUME + repeatedly to select the desired tuning interval.
2 Press TUNER/BAND to select the band, FM or AM. 3 Press PRESET â or 5 (or PRE DOWN 8/2 or PRE UP 3/8 on the remote control) to select the desired preset number.
PRESET DIRECTION PLAY/PAUSE
â 10 â