I purchased the unit from a private party and the original owners manual was not available. Having the ability to download it was extremely helpful and clarified operating the equipment immensely. This is a complicated unit and without the manual I would not have been able to maximize it's potential. Thank you.
Being a user of older radios of many kinds, preferring them over more modern rigs, this manual was invaluable in the programming of my two. I now know for certain what the assorted buttons functions are, and am very grateful to have found this excellent site. Many thanks for your assistance, Tony.
5 star quality on these downloadable manuals. Easy to read and all the information is there. A must when doing a custom install or needing to service your precious old school electronics.
Text excerpt from page 12 (click to view)
English
AM antenna
Connecting Speakers
]
]
1
2
3
ANTENNA
1
AM EXT AM LOOP
Vinyl-covered wire (not supplied)
RIGHT LEFT
Red Speaker cord
MAIN SPEAKERS
Speaker cord
FM 75 COAXIAL
SPEAKER IMPEDANCE MIN 4
Black
2
AM loop antenna (supplied) Right speaker Left speaker
1 Connect the AM loop antenna to the AM
LOOP terminals as illustrated.
� If the AM loop antenna wire is covered with vinyl, remove the vinyl by twisting it as shown in the diagram.
1 Press and hold the clamp of the speaker
terminal on the rear of the unit.
2 Turn the AM loop antenna until you have the
best reception.
To connect an outdoor AM antenna
When reception is poor, connect a single vinyl-covered wire to the AM EXT terminal and extend it horizontally. (The AM loop antenna must remain connected.)
2 Insert the end of the speaker cord into the
terminal.
Match the polarity of the speaker terminals: Red (+) to red (+) and black (�) to black (�).
3 Release the finger from the clamp.
IMPORTANT: Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the unit.
For better reception of both FM and AM � Make sure the antenna conductors do not touch any other terminals and connecting cords. � Keep the antennas away from metallic parts of the unit, connecting cords, and the AC power cord.