There are currently no product reviews.
It was a complete manual as stated. Very good source for older product manuals. Thanks
Scan quality is very good. Price is very reasonable. If you're looking to purchase a copy of this manual, this is the one to get.
Perfect for my use.Could have better pictures,but otherwise perfect ;)
This is one of four manuals I have downloaded recently.
Purchase was very straight forward and the authorising email arrived in about 4 hours.
The quality of the scan is good. Print is clear and square to the page edges.
Exactly as advertized. High quality digital copy of the Nak 610 user manual. Easy download and access. Highly recommended.
Listening to FM and AM (MW) Broadcasts
Tuning in to a Station Presetting Stations
You can preset 30 FM and 15 AM (MW) stations manually.
1 Press FM/AM to select either âFMâ
The unit automatically turns on and tunes in to the previously received stationâeither FM or AM (MW). â¢ Each time you press the button, the band alternates between FM and AM (MW).
In some cases, test frequencies have been already stored for the tuner since the factory examined the tuner preset function before shipment. This is not a malfunction. You can preset the stations you want into memory by following the presetting method. â¢ There is a time limit in doing the following steps. If the setting is canceled before you finish, start again from step 2.
On the remote control ONLY:
2 Press and hold Â¢ or 4
(or Â¢ UP or 4 DOWN on the unit) for more than 1 second.
â¢ Â¢ (Â¢ UP): Increases the frequencies. â¢ 4 (4 DOWN): Decreases the frequencies. The unit starts searching for stations and stops when a station of sufficient signal strength is tuned in. â¢ If an FM program is broadcast in stereo, the STEREO indicator lights up on the display (only when the reception is good). To stop during searching, press Â¢ or 4 (or Â¢ UP or 4 DOWN on the unit).
1 Tune in to the station you want to preset.
â¢ See âTuning in to a Station.â
2 Press SET.
âSETâ starts flashing on the display.
DISC UP or
DOWN to select a preset number.
When you repeatedly press Â¢ or 4 (or Â¢ UP or 4 DOWN on the unit) The frequency changes step by step.
You can also select the preset number using the number buttons. Ex.: For preset number 5, press 5. For preset number 15, press +10, then 5. For preset number 20, press +10, then 10. For preset number 30, press +10, +10, then 10.
1 4 7 10
2 5 8
3 6 9 +10
To change the FM reception mode
On the remote control ONLY:
When an FM stereo broadcast is hard to receive or noisy, press FM MODE so that the MONO indicator lights up on the display. Reception will improve.
To restore the stereo effect, press FM MODE again so that the MONO indicator goes off. In stereo mode, you can hear stereo sound when a stereo program is broadcast.