|
Who's Online
There currently are 6008 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
IF PRINTED CIRQUIT BOARD WIRING VIEW WAS ONE TONE LIGHTER, THEN 5 STAR RANK HAS TO BE MY CHOISE.
;
Very usefull, good quality drawings !
Muito útil encontrei todas as informações necessárias.
;
Wanting to repair a neighbours tape recorder I needed the necessary information, it makes it easier. Although the service manual is described as "Language : English" To my dismay I found that it is entirely written in German, a language I do not understand. At least I now have the schematics which will help of sorts. I may not use this service again due to the laguage difficulty after all when it states English you do not expect it to be entirely in another language.
;
GOOD SERVICE MANUAL.I ALWAYS BUY THERE IF I FIND WHAT I AM LOKING
;
Good quality (clearly readable) manual, I'm glad I could find it here, at a bargain price!
UX-T77 <<Cassette mechanism section>>
Cassette mechanism Removing the Playback/Recording & Eraser Head (See Fig. 1 to 3) 1. While shifting the trigger arms seen on the right side of the head mount in the arrow direction, turn the flywheel R in counterclockwise direction until the head mount has gone out with a click (See Fig. 1). 2. When the flywheel R is rotated in counterclockwise direction, the Playback/Recording & Eraser head will be turned in counterclockwise direction from the position in Fig. 2 to that in Fig. 3. 3. At this position, disconnect the flexible P.C. board (outgoing from the Playback/Recording & Eraser head) from the connector CN31 on the head amplifier & mechanism control P.C. board. 4. After dismounting the FPC holder, remove the flexible P.C. board. 5. Remove the flexible P.C. board from the chassis base. 6. Remove the spring 1 from behind the Playback/Recording & Eraser head. 7. Loosen the reversing azimuth screw retaining the Playback /Recording & Eraser head. 8. Take out the Playback/Recording & Eraser head from the front of the head mount. 9. The Playback/Recoring & Eraser head should also be removed similarly according to Steps 1 to 8 above.
Flywheel R
Head mount
Trigger arm
Fig. 1
Playback/Recording & eraser head Flexible board Spring 1 Trigger arm
CN31 Reassembling the Playback/Recording & Eraser head (See Fig.3) 1. Reassemble the playback head from the front of the head mount to the position as shown in Fig. 3. 2. Fix the reversing azimuth screw. 3. Set the spring 1 from behind the Playback/Recording & Eraser head. 4. Attach the flexible P.C. board to the chassis base, and fix it with the FPC holder as shown in Fig. 3. 5. The Playback/Recording & Eraser head should also be reassembled similarly to Step 1 to 4 above. Head amplifier & mechanism control P.C. board Flywheel R
Fig. 2
Playback/Recording & eraser head Reversing azimuth screw
Spring 1
Head mount Flexible board
CN31 FPC holder Head amplifier & mechanism control
Fig. 3
P.C. board
1-12
|
|
|
> |
|