Very fast, clear and usefull site !
Also this Service Manual are very well maked and with a very good definition !
Very fast download speed !
Recomended Seller !
The Technics manual was very clear and I was able to solve my technical problems.
I did not think that anyone kept these manuals and was pleasantly surprised to find them on the Internet and at an affordable price.
I would recommend Owner Manuals as a first source of technical products for ‘dated’ equipment manuals.
Ian
The content of the manual was not found on the Internet and was a hard find. I check the net for 5 hours until I came across this web-site. When I did find the book it Auto loaded into my IPAD PDF shelf for books for review at anytime. Overall I am satisfied with the book and it answered all my questions. This repair book is obsolete because the product I bout it for is pretty old. Thanks for the help with the download and even having the manual. Thanks 73's K5HRD
Text excerpt from page 13 (click to view)
VS-DT9
Attaching the pickup unit (See Figs. 6 to 8.)
[Reference] Refer to the explanation of "Removing the pickup unit" on the preceding page. 1. Attach the P.S. spring and rack plate to the pickup unit. (See Fig.6.) 2. Insert the shaft into the pickup unit. (See Fig.6.) 3. Engage the section f of the pickup unit with the traverse mechanism assembly first, and set the both ends of the shaft in the grooves g and h. (See Fig.7.) 4. After making sure that the section j of the rack plate is meshed correctly with the middle gear, attach the shaft using the two screws F. (See Fig.8.) Fig.7
Section j Groove g
Section f
Groove h
F
Rack prate
Fig.8
Removing the traverse mechanism board (See Fig. 9.)
Remove the CD servo board. Remove the traverse mechanism assembly. 1. From the back side of the traverse mechanism assembly, disconnect the spindle motor wires and feed motor wires that are soldered on the traverse mechanism board. 2. Remove the two screws J attaching the traverse mechanism board.
J
Traverse mechanism assembly
Spindle motor Black Red Red Traverse mechanism board
K
Feed motor
J
Removing the feed motor (See Fig. 9.)
Remove the CD servo board. Remove the traverse mechanism assembly. 1. From the back side of the traverse mechanism assembly, disconnect the feed motor wires that are soldered on the traverse mechanism board. 2. Remove the two screws K attaching the feed motor.