Thank you for having the manual I needed for an older model Aiwa stero I had found on Ebay --- I wanted the Aiwa because I had tapes and cd's but I did not have a manual as to how to operate the system... I found what I needed and it has enabled me to set the system up for my enjoyment.
I wished detailed information of the JBL S310 and here I found it! Very happy with the service from this site!
Text excerpt from page 6 (click to view)
Installation and Connection (WB-1540)
Disassembling the Housing
Main Housing Unit
Dismantle the gasket and gasket gland
Loosen the 6 Screws B (M4) using a driver, followed by dismantling the gasket and gasket gland from the lower housing. T The 6 Screws B (M4) cannot be totally removed from the gasket to prevent it from falling off.
Dismantle the lower housing
Loosen the 3 Screws A (M4 x 6) using a driver, followed by dismantling the lower housing from the main housing unit. T The lower housing is connected to the main housing unit using a safety wire.
Screw A (M4 x 6) x 3 Lower Housing Safety Wire Gasket
CAUTION: Pay careful attention to store the dismantled parts and screws until assembly is complete to prevent them from being misplaced.
Screw B (M4) x 6
Mounting the Camera (TK-C625)
Interior of Housing
JVC Mark Notch
Before mounting. Remove the ceiling mount cover of the camera and guide the cables supplied with WB-1540 through the cover. T For further details, please refer to the instruction manual of the camera in use.
Camera Mounting Bracket
Connect the AC 24 V output cable to the camera
Connect the AC 24 V output cable of the main board to the cameraâs ceiling mount bracket.
Connect other cables
Connect the necessary cables supplied with the housing (coaxial video cable, communication cable, etc.) to the ceiling mount.
Safety Wire Main Board Cables Cover FRONT Mark
CAUTION: â Connect the communication cable to the [ALARM IN/OUT] and [CONTROL] terminals if necessary. For safety reasons, ensure to cut off any excess cable and bind using an insulating tape before use. â For further details on connection, please refer to the instruction manual of the camera in use. â Ensure to bind connectors of LAN cables and DC 12 V Power Cable that are not in use with an insulating tape before use.
AC 24 V Output Cable
To [POWER INPUT AC 24 V] Terminal of Ceiling Mount
Mount the cameraâs ceiling mount to the main housing unit.
Use the 4 screws supplied (M4 x 20) to mount the ceiling mount to the main housing unit.
Screws Supplied (M4 x 20) x 4
NOTE: During mounting, align the [D FRONT] Mark of the ceiling mount with the notch on the camera mount bracket of the main housing unit.
Mount the camera to the ceiling mount
Follow instructions in the manual of the camera in use to mount the camera to the ceiling mount.