|
Who's Online
There currently are 5971 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
- Very good scan quality, PERFECT!
- Sehr gute scan Qualitaet, empfehlenswert!
Wolfgang Sundhaus
;
Good site, works ok and you get what you order, no problems experienced, got my manual within a day. A++++
;
Original well scanned manual. Got the job done. Microwave problem found & corrected. For $5 and a new magnitron from ebay, it was a cheap and good the first shot fix. Electrical schematics allowed me to mage sure every thing else was ok before cutting and order for parts. Hard to live without.
;
I was very skeptical of this website, I have never downloaded manuals before. I put it on the AMEX and payed through Paypal to ensure protection. I got the manual exactly as described and now I can replace the filter capacitor for this amp. Great Price, others selling for 12.99 or more and this is the same manual. I will search out this website for other manuals. Thank you
;
Manual was reasonably easy to follow. I am not an engineer or know much about electronics but with the manuals help I was able to figure out the problem, identify the part required for the repair. Replacement part cost around $30. Whilst replacing the part I was telling myself, "this aint gonna work cos it seems far too easy". Took about 15 minutes to do and my plasma TV works a treat. Would never have been able to do this without the service manual.
XM-PX50WT
<Removal of the MD mechanism section>
Prior to performing the following procedures, remove the MD door assembly, the holder assembly, the chassis assembly and the main board.
Slit washer Worm gear
Shaft holder Soldering g
J
I
Removing the spindle motor (See Fig.11)
1. Unsolder the part g on the flexible wire extending from the underside of the Chassis assembly to the spindle motor. ATTENTION: Do not spill flux on the gear and others. 2. Remove the three screws I motor. attaching the spindle
Chassis assembly Part i Part h Pickup unit
Spindle motor
Fig.11
Removing the pickup unit (See Fig.11)
ATTENTION: When handling the Pickup unit, touch the parts marked in Fig.13 only. 1. Remove the slit washer and the worm gear from the underside of the Chassis assembly. 2. Remove the screw J attaching the shaft holder and draw out the shaft (lead screw). 3. Pull out the Pickup unit and the lead screw while disengaging the part h and i.
Lead screw
K
Lead spring
Pickup
Fig.12
Removing the pickup (See Fig.12 and 13)
Touch these parts only.
ATTENTION: When handling the pickup unit, touch the parts marked in Fig.13 only. 1. Remove the screw K and the lead spring. 2. Pull out the shaft from the pickup.
Fig.13 1-8
|
|
|
> |
|