JVC XV-FA92SL
Owner's Manual

Initial settings

2 Select the desired speaker(s) to be set using
CURSOR 5/�.
� F.SP : Front speakers. The level is fixed to 0dB. � C.SP : Center speaker � R.SP : Rear speakers � S.WOOFER: Sub-woofer The setting range is between �6dB and +6dB in 1dB steps.

Test tone (available only while setting LEVEL or DELAY)
You can check the level setting by monitoring the test tone.
PREFERENCE1 PREFERENCE2 SPK.SETTING
EXPERT LEVEL

English

DELAY

BA
PRESS

SS
KEY

C. SP F. SP R. SP
S.WOOFER

0dB 0dB 0dB 0dB

TEST TONE

3 Set the level using CURSOR 2/3.
� For the speaker(s) whose size is set to �None� the Speaker , level and Delay cannot be set (���appears in the setting field). � However, when playing back a Dolby Digital disc, LFE signal is output from SUBWOOFER output even if S.WOOFER shows ��� allowing to activate a sub-woofer , connected. In such case, adjust the output level using the level control on the sub-woofer.

1 Select [TEST TONE] using CURSOR 5/�,
then press ENTER.
The color of �TEST TONE� changes.

2 Select the desired speaker(s) using CURSOR
5/�.
� F.SP : Front speakers � C.SP : Center speaker � R.SP : Rear speakers After selecting the Test tone, if you do not move the cursor, the test tone is output from each speaker one by one. In Test tone mode, if you move down from �R.SP� position, the test tone continues to output from the rear speakers as long as is any position other than �F .SP� and �C.SP� Similarly, if you move . up from �F .SP� position, the test tone continues to output from the front speakers as long as any position other than �C.SP� and �R.SP� . is

Delay (available only when selecting EXPERT)
You can adjust the delay time of each speakers.
PREFERENCE1 PREFERENCE2 SPK.SETTING
EXPERT

LEVEL DELAY

BASS
PRESS KEY

C. SP F. SP R. SP
S.WOOFER

0mS 0mS 0mS 0mS

TEST TONE

1 Select [DELAY] using CURSOR 5/�, then
press ENTER.
The color of �DELAY� changes.

3 Set the level using CURSOR 2/3 again, if
necessary.
� In Test tone mode, you hear pink noise, which includes all frequencies in the audible range, from the speakers. This is not a malfunction. � The test tone is not output from the SUBWOOFER output.

2 Select the desired speaker(s) to be set using
CURSOR 5/�.
� F.SP : Front speakers. The delay is fixed to 0ms. � C.SP : Center speaker (selectable from 0 to �5ms in 1 ms units) � R.SP : Rear speakers (selectable from 0 ms, �5ms, �10 ms, and �15 ms)

� To exit the test tone mode Move to [TEST TONE] in the on-screen display and press ENTER until [TEST TONE] returns to its original color.

3 Set the delay time using CURSOR 2/3.
� Delay of S.WOOFER cannot be set.

NOTE
� To exit the speaker level (or delay) setting mode Move to [LEVEL] (or [DELAY]) in the on-screen display and press ENTER until [LEVEL] (or [DELAY]) returns to its original color.

63

Initial settings

NOTE