|
Who's Online
There currently are 5796 guests and 4 members online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Good site, works ok and you get what you order, no problems experienced, got my manual within a day. A++++
;
Original well scanned manual. Got the job done. Microwave problem found & corrected. For $5 and a new magnitron from ebay, it was a cheap and good the first shot fix. Electrical schematics allowed me to mage sure every thing else was ok before cutting and order for parts. Hard to live without.
;
I was very skeptical of this website, I have never downloaded manuals before. I put it on the AMEX and payed through Paypal to ensure protection. I got the manual exactly as described and now I can replace the filter capacitor for this amp. Great Price, others selling for 12.99 or more and this is the same manual. I will search out this website for other manuals. Thank you
;
Manual was reasonably easy to follow. I am not an engineer or know much about electronics but with the manuals help I was able to figure out the problem, identify the part required for the repair. Replacement part cost around $30. Whilst replacing the part I was telling myself, "this aint gonna work cos it seems far too easy". Took about 15 minutes to do and my plasma TV works a treat. Would never have been able to do this without the service manual.
;
It is OK, this manual help me to repair my dynacord
2.1.5 Removing the rear panel (See Figure 8, Figure 9) � Prior to performing the following procedure, remove the top cover. (1) Remove the six screws E attaching the rear panel. (2) Disconnect the power cord from connector P901 on the power supply board (3) Remove tie band.
Rear panel
E
G G
E
Fig.8
E
CN901 P901
H Tie band Power cord
CN702 Output terminal board
2.1.6 Removing the output terminal board and power supply board. (See Figure 9) � Prior to performing the following procedure, remove the top cover/mechanism assembly/rear panel. (1) Remove the two screws G attaching the output terminal board. (2) Disconnect the card wire from connector CN702 on the output terminal board. (3) Remove the three screws H attaching the power supply board. (4) Disconnect the card wire from connector CN901 on the power supply board.
HH Power supply board Fig.9
1-10 (No.XA003)
|
|
|
> |
|