|
|
|
Who's Online
There currently are 5939 guests and
2 members online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
It was just what I needed. Thanks for your quick action and great price. You guys are top notch.
Thanks
 ;
Excellent manual, complete, great resolution, easy to read especially the schematics. Thank you !
;
Fast delivery, excellent resolution and complete. And above all, the best price ever !
;
Vielen Dank,
das war eine prima Sache. Habe das Serviceheft nach 3 Stunden herunterladen können. Qualität OK. Hat mir mit Erfolg bei der Fehlersuche und Reparatur meines
Nordmende Galaxy Mesa 9000 geholfen. Ich kann diesen Service bestens weiterempfehlen
A very good service.
Thank You!
;
everything i needed. it was easy to get. and this site is now my go to site for manuals.
2.1.5 Removing the rear panel (See Figure 8, Figure 9) � Prior to performing the following procedure, remove the top cover. (1) Remove the eight screws F attaching the rear panel. (2) Disconnect the power cord from connector P901 on the power supply board (3) Remove tie band.
Rear panel
F
F
Fig.8
F
G
G
H
CN901
CN731 CN101 CN502
H P901
CN902,CN903 H Servo control and signal output terminal board
Fig.9 2.1.6 Removing the servo control and signal output terminal board. (See Figure 9) � Prior to performing the following procedure, remove the top cover/rear panel. (1) Remove the two screws G attaching the servo control and signal output terminal board. (2) Disconnect the wire from connector CN101,CN502,CN731 on the servo control and signal output terminal board. (3) Disconnect the flat wire from connector CN902,CN903 on the power supply board. 2.1.7 Removing the power supply board. (See Figure 9) � Prior to performing the following procedure, remove the top cover/rear panel. (1) Remove the three screws H attaching the power supply board. (2) Disconnect the wire from connector CN901,CN902, CN903,CN904 on the power supply board. (3) Disconnect the socket wire from socket P901 on the power supply board. 2.1.8 Removing the MIC amplifier board. (See Figure 10) � Prior to performing the following procedure, remove the front panel assembly. (1) Remove the two screws I attaching the bracket. (2) A MIC amplifier board is drawn out. At this time, a MIC volume knob also separates simultaneously.
Power supply board
Front panel assembly
I
I
MIC Amplifier board
Fig.10
(No.XA007)1-9
|
|
|
> |
|
