|
|
|
Who's Online
There currently are 6043 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
A complete manual with all the needed details of calibrations and service instructions about the radio receiver.
A big deal.
Many thanks !
;
Fast delivery and good quality copy. To be recommended
;
Excellent product, very clear print. Detailed circuit and assembly diagrams - this enabled me to repair my CD player with confidence. I highly recommend this site.
;
Fast access, 100% correct and complete service manual
;
just what i was seeking .had a password issue but the review allowed me to circumvent and download was great
XV-S40BK/XV-S42SL/XV-E100SL
Disassembly method
There is a part different from the photograph according to the model and the destination though explains this disassembly method by using XV-E100SL.
<Main body> Removing the top cover (see Fig.1)
1.Remove the two screws A attaching the top cover on both sides of the body. 2.Remove the three screws B attaching the top cover on the back of the body. 3.Remove the top cover from the body by lifting the rear part of the top cover. ATTENTION: Do not break the front panel tab fitted to the top cover. CN703 CN702 C C Ax2 Fig.1 B F Lug wire Mechanism assembly B
B
Removing the mechanism assembly (see Fig.2,3)
* Prior to performing the following procedure, remove the top cover. * There is no need to remove the front panel assembly. 1.Remove the three screws C attaching the mechanism assembly on the bottom chassis. 2.Remove the two screws F attaching the lug wire and main board on the bottom chassis. 3.The servo control board is removed from the connector CN961 and CN701 connected with the main board respectively. 4.Remove the mechanism assembly by lifting the rear part of the mechanism assembly. CN701 Fig.3 CN961
Main board Servo control board
C Main board Fig.2
Mechanism assembly
F
Removing the servo control board (see Fig.4)
* Prior to performing the following procedure, remove the top cover and mechanism assembly. 1.Disconnect the card wire from connector CN201 and CN202 on the servo control board respectively. 2.Disconnect the flexible wire from connector CN101 on the servo control board from pick-up. < ATTENTION > At this time, please extract the wire after short-circuited of two places on the wire in part a with solder. Please remove the solder two places of part a after connecting the wire with CN101 when reassembling. 3.Two places in hook b are removed, the servo control board is lifted, and it is removed. Fig.4
Hook b
Hook b
Servo control board
1-7
 $4.99 XVS40BK JVC
Owner's Manual Complete owner's manual in digital format. The manual will be available for download as PDF file aft…
|
|
|
> |
|
